See How to Hang a Birdhouse for the recommended mounting height for various birds. Mount your birdhouse and see which bird will call your habitat home. This finish helps accentuate the grain and helps make the wood more resistant to damage. Optionally paint or finish your birdhouse. Find other ways to add a clean out door to this birdhouse. This way, it can later be opened for cleaning. If you pre-drill the holes, these screws will countersink themselves nicely because the head is not much larger than the pilot hole.Īttach the roof to the birdhouse using only screws. The smaller screw head is less obvious and helps prevent the wood from splitting. Personally, I recommend using stainless steel trim screws as shown below. Ideally the pilot holes should be at least as large as the screw’s minor diameter. Drill pilot holes to help prevent the wood from splitting. A waterproof wood glue is recommended to help extend the life of the birdhouse. Now, use a combination of glue and screws to attach the sides, base (floor), and the roof of the birdhouse together. Assemble the bird house.Īltogether, you should now have six roof sections (labeled “A” on the image below), the base or the floor (labeled “B”), and six sides (labeled “C”). Here you will find the required miter and tilt cuts necessary for other angles. If you wish your roof to be at a different angle see segmented wood turning. When assembled, the roof will be at a 43 degree angle. When finished each piece should be approximately 5.5″ x 5″ (14cm x 12.5cm). See Bird House Hole Size if you want to attract a specific bird.Ĭut six pieces for the roof with a 21.5 degree tilt and a 21.5 degree miter cut. However, chickadees, nuthatches, warblers, woodpeckers, and wrens will also gladly make this their home. A 1.5″ (4 cm) entrance hole is the optimum diameter for bluebirds and tree swallows. Drill the entrance hole for the birdhouse.ĭrill a hole for the entrance using either a spade bit or forsnter drill bit. Each piece should be 6″ x 3.5″ (15cm x 9cm). Create the sides of the gazebo bird house.Ĭut six pieces for the sides on a table saw or miter saw with the blade set at a 30 degree tilt. If so, when assembling leave a small gab between the two pieces for drainage. Note, two smaller pieces of wood can also be used for the bottom. Drill several 1/4″ (0.5 cm) holes in the floor for drainage. The distance from one side to the other side should be 7″ (18 cm). Prepare the base or the bottom of the bird house.Ĭut a 6-sided (hexagon) using a miter saw, table saw, band saw, or other saw.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |